![]() Press the MENU button to select Remote control setting, then press the REC/ENTER button.Check the System Software version Follow the instruction to confirm the System Software version is Ver.Note: Turn OFF the device and then turn ON the device again. Click Finish and disconnect the USB cable. Complete the update When the update is completed, the screen below appears.Note: Never turn off the device nor disconnect the USB cable while updating. The progress bar appears while updating (approximately 10 minutes). After resetting, reconnection of the device is verified, and the screen below appears.Note: The screen turns off when the ENTER button is pressed. Note: Please keep the USB cable connected even after stopping the USB connection on the computer with the above operation Click on the task tray at the lower right corner of the computer screen to stop the USB connection.According to the message, stop the USB connection and click Finish. * Update is required *Update is not required Note: If the screen on above appears, the update is not required. After confirming Current version is Ver.1.00, click Next.The current version and the version after the update appear on the lower left part of the screen. After confirming the screens above, click Next.Check if System Software update is required.Note: From now on, never turn off the device until the system software update is completed. Figure below appears on Firmware Updater and on the LCD monitor of the device respectively. Start the Firmware Updater“.Īt this time, confirm is displayed on the task tray at the lower right corner of the computer screen.Īfter confirming the above, click Next on Firmware Updater. In this case, remove the battery pack from the device, reboot the computer, and follow the procedures from “2. Sometimes when the device is connected to the computer with the USB cable, the message to encourage rebooting the computer may appear on the computer display. (Your computer may have some USB terminals on the backside.) * If the computer has multiple USB terminals, try with the other terminals. * Disconnect the USB cable and connect it again. If the computer cannot find the device, the message “ Could not find the device for this update.” appears on the computer display. ”USB Mode” appears on the LCD monitor of the device. Connect the device to the computer with the supplied USB cable.Double-click the downloaded file Update_RMLVR2V2.exe.Close all currently running programs on your computer.Click the Desktop tile from the Start screen and find the downloaded file in the Downloads folder by using Explorer. For Windows 8 users: Under the initial settings of Internet Explorer, the update file will be saved in the Downloads folder. Note: If you want to know how to use new functions, please download and refer to the Instruction Manual above. Please save the downloaded file onto the Desktop of your computer (recommended). Download the update file Click on one of the file Update_RMLVR2V2.exe to begin download.Note: Update functionality is not guaranteed with any other USB cable. We recommend that you use it in the state where it fully charged. Note: Please close all other application software before updating the system software and prevent your computer from going into Sleep Mode. Other system requirements - Hard disk space: 200MB or more - RAM: 512MB or more Supported OS - Windows 10 - Windows 8.1 - Windows 7 SP1 Instruction Manual of this firmware update: *2: Only available with compatible cameras. *1:Only available with compatible cameras. Time zone of some areas has been changed.Date & time/area/daylight saving time (summer time) setting has been changed.*1 -White balance setting -AE shift setting -Audio recording setting -Wind noise reduction setting -Loop recording interval setting The following features have been added to camera setting. ![]() “Loop recording” mode has been added to shooting mode setting.Live-View Remote RM-LVR2V (Supplied with HDR-AZ1 Model Series)Īpplicable system software version of the units This update is only applicable for product with the System Software version “Ver. Sony is offering a system software update for Live-View Remote RM-LVR2. Thank you for your continued interest in Sony products.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |